EXIT TO THE SITE OF THE SELECTOR

For the sampling of the organization together with the supervising organization (parallel test), it is possible to plan a visit of
our specialist. To call a specialist, it is necessary to apply in advance in order to conclude a contract and travel to
the place of selection.

The application is submitted by the organization in an arbitrary form by e-mail lab.reagent@mail.ru

Departure to the Customer is carried out by informing at least 1 hour before the sampling.

                   

 RECOMMENDATIONS FOR RIGHT SELF SELECTION OF WATER TEST

Correct sampling of water leads to correct results of the analysis of your water. Observe the following sampling recommendations:

 
RECOMMENDATIONS FOR SELECTING WATER TUBES FROM WELL
  • The bottle for sampling water should be from under simple drinking water. Bottles from under the "Fanta", "Cola", etc. are not used.
  • Allow to drain water for 5-10 minutes.
  • Bottle and stopper several times thoroughly rinse with water that is taken for analysis. Do not use detergents.
  • Water is best poured neatly on the wall of the bottle, so that air bubbles in the water were as small as possible.
  • The bottle is completely filled with water "with overflow", trying to keep it a minimum of air. Close tightly with a stopper.
  • The sample should be marked.

The amount of sampled water for analysis should be at least 1.5 liters. To clarify the volume of the sample, be sure to call the laboratory. the volume of water will depend on the specific analysis of the sample. Also need to clarify in a plastic or glass container you will need to select a sample.

Only compliance with these rules will get the right result.

 

RECOMMENDATIONS FOR SELECTING WATER TEST FROM WELL

  • Scoop water from the well with well-washed containers (bucket, etc.).
  • Wash the bottle with the lid closed with water from the container by pouring the bottle. Open the lid and scoop water from the container (bucket, etc.), filling the bottle under the throat, so that there is no air layer left in the throat of the bottle.
  • After filling the bottle up to the top, it is necessary to squeeze its walls a little and seal the lid tightly to avoid air ingress. Close the lid until it clicks and do not open it again.
  • The bottle should be transported to the laboratory within 5-6 hours after water extraction. Before delivery to the laboratory, the sample is recommended to store a bottle of water in a dark and cool place (a usual household refrigerator is recommended)